不锈钢电缆桥架安装过程存在很多的问题，下面为大家介绍安装时应该注意哪些呢？
There are many problems in the installation process of stainless steel cable tray. What are the following points for installation?
1、钢制电缆桥架严禁作为人行通道、梯子或站人平台.其支吊架不得作为吊挂重物的支架使用,在钢制电缆桥架中敷设电缆时,严禁利用钢制电缆桥架的支吊架做固定起吊装置,做拖动装置及滑轮和支架.
1. The steel cable bridge is strictly prohibited as a pedestrian passage, ladder or platform. Its hanger should not be used as a support for lifting heavy objects. When laying cable in steel cable bridge, it is strictly forbidden to use the support and hanger of steel cable bridge to be a fixed lifting device, a drag device, a sliding wheel and a support.
2、当钢制电缆桥架表面有绝缘涂层时,应将接地点或需要电气连接处的绝缘涂层清除干净.
2, when there is insulating coating on the surface of the steel cable tray, the grounding point or the insulating coating that needs electrical connection should be cleaned up.
3 钢制电缆桥架在振动场所及电气接地部位的连接螺栓应加装弹簧垫圈.
3 steel cable tray should be equipped with spring washers for connection bolts in the vibration location and electrical grounding area.
4 、对于安装在钢制支吊架上或用钢制附件固定的铝合金钢制电缆桥架.当钢制件表面为热浸锌时,可以和铝合金桥架直接接触.当其表面为喷涂粉末涂层或涂漆时,则应在与铝合金桥架接触面之间用聚氯乙稀或氨丁橡胶衬垫隔离.
4. The aluminum alloy steel cable bridge installed on the steel supporting hangers or with steel accessories. When the surface of the steel is hot dipped, it can be directly contacted with the aluminum alloy bridge. When the surface is sprayed with powder coating or paint, it should be separated from the aluminum alloy bridge between the contact surface of the aluminum alloy bridge and the polychloroprene or amneiene rubber liner.
5 、在有腐蚀性环境条件下安装的钢制电缆桥架.应采取措施防止损伤钢制电缆桥架表面保护层,在切割、钻孔后应对其裸露的金属表面用相应的防腐涂料或油漆修补.
5. Steel cable bridge installed in corrosive environment. Measures should be taken to prevent damage to the surface protection layer of steel cable bridge. After cutting and drilling, the surface of the exposed metal surface should be repaired with corresponding anticorrosive coating or paint.